Particular Kanji Font did not output to the "Cutting Master 3".Ĭorresponded to the Adobe Illustrator CC2017.įixed the problem that a small circle is drawn with a short straight line command instead of a circular command.įixed the problem that the location of registration marks is not corresponded the result of Illustrator clipping mask.įixed the problem that the registration mark settings are reset to the previous setting instead of the default.įixed the problem that it may take time to start cutting with some data.įixed the problem that the Convert rectangle option may not be available when an image is placed.Ĭhanged the function as that the updating of this software is not performed while the Illustrator or Corel DRAW is running.Ĭorresponded to the Adobe Illustrator CC2015.3.įixed the problem that might not be performed the number of times of the specified passes.įixed the problem that the error message windows might be appeared when some operation is executed at the Tile panel.įixed the problem that might not be displayed a part in the screen when it is operated the Cut Line Pattern in edit of condition settings.Ĭorresponded to the FC4550. (This problem occurred on the FC8600/8000 only.) Scanning error occurred when the 3rd of row is scanning if the Cross cutting with
#Straighten lines corel draw 2018 manual
(*5) Although the Windows XP / Vista is included in the system requirements on the user's manual for the Cutting Master3, GRAPHTEC has terminated to support it. (*4) When both of the CorelDRAW X8 64-bit and 32-bit are installed, the Cutting Master 3 cannot be used. (*3) The firmware needs to be the follwong version.ĬE5000 series: version 3.80 to version 4.90 Please resave the data file in a format other than the Illustrator 9 using the Illustrator CS5 or older edition before opens the data file by the Illustrator CS6 and later editions. Please resave the data file to Illustrator 8 format in the Illustrator 9 before opens the data file by the Illustrator CS6 and later editions. It occurs when the illustrator 9 format data is opened by the Illustrator CS6 and later editions.
It is issue of the Illustrator CS6 and later editions. The cause of this phenomenon is not the Cutting Master 3. The Cutting Master 3 cannot to recognize registration mark because the name of layer for the registration mark is also changed.
When the data file in the Illustrator 9 format is opened using the Illustrator CS6 and later editions, the name of all layers are changed to "layers". (*2) Notice for using the Illustrator CS6 and later editions. (*1) On software, it is run in the WOW64 mode (32-bit emulation mode) when the 64-bits Windows OS is used. The Cutting Master 2 needs to be closed before the Cutting Master 3 is started. (*) The Cutting Master 3 and the Cutting Master 2 cannot be used simultaneously.